| I followed the instructions and got the bolt apart. It was solidly packed with cosmoline. After afew minutes of rubbing and scrubbing, it was clean. I lightly oiled it and reassembled it. I fired two rounds just to make sure it worked.
By the way, when you are compressing the firing pin spring with the bolt head, be careful. I pinched the #@*&$%# out of my hand when I tried to turn the bolt head 90°, while holding the pin from turning.
So I got a piece of 4x4 and drilled a hole for the fireing pin to fit into, down to the point where it widens out, and pressed down and turned it right off. No Problem. The pin was held from turning by the wood, making turning the bolt head much easier.
Nick
Last edited by ninwnc; 01-24-2008 at 09:38 AM.
|