Gun and Game Forums - View Single Post - The brass/metal circle in the rear of stock

wunhunglo · 03-21-2008, 04:39 AM

"To use the take down disk. Place the firing pin tip into the hole and the firing pin safety shoulders will rest on the disk. Keep the assembly vertical and do not accidentally bend the tip.
Keeping the safety vertical, place your thumb over the safety, grip the bolt sleeve and compress the spring. With the other hand, as soon as the cocking piece turns freely, rotate it 1/4 turn in either direction, lift off, and gently release pressure on the spring.
The bolt sleeve and spring will slide off the firing pin. Turn the safety to the right and remove."

Have you looked at this site?
K98k Mauser Page

03-21-2008, 04:39 AM	#5
wunhunglo Senior Member Join Date: Dec 2007 Location: currently "Sunny West Africa" Posts: 1,107	"To use the take down disk. Place the firing pin tip into the hole and the firing pin safety shoulders will rest on the disk. Keep the assembly vertical and do not accidentally bend the tip. Keeping the safety vertical, place your thumb over the safety, grip the bolt sleeve and compress the spring. With the other hand, as soon as the cocking piece turns freely, rotate it 1/4 turn in either direction, lift off, and gently release pressure on the spring. The bolt sleeve and spring will slide off the firing pin. Turn the safety to the right and remove." Have you looked at this site? K98k Mauser Page Last edited by wunhunglo; 03-21-2008 at 04:43 AM.