Bolt disasembly????

Doglips · 03-27-2002, 12:19 PM

Ok Ive pulled trised, pried and and currently warming up the cutting torch....Like the Mosans I am sure that there is something silly and easy that I am flat over looking...
So, how does one take the bolt of a turkish mauser apart to clean and check the fireing pin, springs ect?

Will · 03-27-2002, 07:13 PM

Bob - Here's a link to some good instructions...

http://www.bobtuley.com/mauser/

Will

Shaun · 03-27-2002, 10:43 PM

try this for instructions

Doglips · 03-27-2002, 11:05 PM

Got it cleaned it...and tried it on a empty case..primer only..made a bigger dent...after 10 trys 1 case fired...2nd case would not...Im goint to pick up some newer ammo....and take it to the range...I guess a few problems from a $40 gun and $5 ammo is to be expected.

Shaun · 03-27-2002, 11:18 PM

Bob I guess you can classify that in the stuff happens category -- glad to hear its working for you

JDW · 04-02-2002, 07:35 PM

I've been using that cheap bandoleer stuff, never had one yet that didn't go bang!
Did you check the headspace? Could that be part of the problem?

03-27-2002, 12:19 PM	#1
Doglips Senior Member Join Date: Mar 2002 Location: Cocoa Florida Posts: 9,090 Trader Rating: (0)	Bolt disasembly???? Ok Ive pulled trised, pried and and currently warming up the cutting torch....Like the Mosans I am sure that there is something silly and easy that I am flat over looking... So, how does one take the bolt of a turkish mauser apart to clean and check the fireing pin, springs ect?

03-27-2002, 11:18 PM	#5
Shaun Super Moderator Join Date: Mar 2002 Location: Nashville, TN Posts: 8,585 Trader Rating: (0)	Bob I guess you can classify that in the stuff happens category -- glad to hear its working for you __________________ "Homeland Security is the responsibility of an armed citizen" ME http://webpages.charter.net/s.s.v/

04-02-2002, 07:35 PM	#6
JDW Member Join Date: Mar 2002 Posts: 36 Trader Rating: (0)	ammo I've been using that cheap bandoleer stuff, never had one yet that didn't go bang! Did you check the headspace? Could that be part of the problem?

03-27-2002, 07:13 PM	#2
Will Member Join Date: Mar 2002 Posts: 32 Trader Rating: (0)	Bob - Here's a link to some good instructions... http://www.bobtuley.com/mauser/ Will

03-27-2002, 10:43 PM	#3
Shaun Super Moderator Join Date: Mar 2002 Location: Nashville, TN Posts: 8,585 Trader Rating: (0)	try this for instructions

03-27-2002, 11:05 PM	#4
Doglips Senior Member Join Date: Mar 2002 Location: Cocoa Florida Posts: 9,090 Trader Rating: (0)	Got it cleaned it...and tried it on a empty case..primer only..made a bigger dent...after 10 trys 1 case fired...2nd case would not...Im goint to pick up some newer ammo....and take it to the range...I guess a few problems from a $40 gun and $5 ammo is to be expected.