Bersa sights help

JSosbe · 08-07-2008, 02:43 AM

My sights line up to the left of center, very noticably. I can't adjust the sight any differently any ideas on how to fix this would be appreciated.

rondog · 08-07-2008, 02:24 PM

Contact these folks, they're a Bersa repair center. Colorado Gun Works: Home

22plinker · 10-24-2008, 12:56 AM

My Bersa Thunder rear sight is "drift adjustable." Take a brass rod, smaller than the side of the sight. Cushion the gun on a solid surface, protecting it with a rag for padding. Holding the brass rod firmly against the side of the REAR sight, tap it with a hammer. Make SURE you know exactly "where" the sight is, before you start "whacking" so you'l know when it moves. Some are tighter than others, but that's how the sight is adjusted. Do NOT use a steel punch! It will damage or "swage" the side of the sight, then you'll have a whole now problem. "THINK" before you move the sight, so you'll correct the problem. Take your time, go slow & easy.....

08-07-2008, 02:43 AM	#1
JSosbe Member Join Date: Jul 2006 Location: University of Kentucky Posts: 90	Bersa sights help My sights line up to the left of center, very noticably. I can't adjust the sight any differently any ideas on how to fix this would be appreciated.

08-07-2008, 02:24 PM	#2
rondog Senior Member Join Date: Aug 2007 Location: Parker, CO Posts: 3,296	Contact these folks, they're a Bersa repair center. Colorado Gun Works: Home __________________ I child-proofed my house, but they still keep getting in!

10-24-2008, 12:56 AM	#3
22plinker Member Join Date: Oct 2006 Location: Yuma, AZ Posts: 84	My Bersa Thunder rear sight is "drift adjustable." Take a brass rod, smaller than the side of the sight. Cushion the gun on a solid surface, protecting it with a rag for padding. Holding the brass rod firmly against the side of the REAR sight, tap it with a hammer. Make SURE you know exactly "where" the sight is, before you start "whacking" so you'l know when it moves. Some are tighter than others, but that's how the sight is adjusted. Do NOT use a steel punch! It will damage or "swage" the side of the sight, then you'll have a whole now problem. "THINK" before you move the sight, so you'll correct the problem. Take your time, go slow & easy..... Last edited by 22plinker; 10-24-2008 at 12:57 AM. Reason: spelling