No.1 MK2 3A

willys · 03-22-2002, 09:57 PM

I have an Enfield NO.1 MK2 3A. has anyone tried to mount a scope to one of these?

warren47 · 03-24-2002, 03:40 AM

I mounted a scope on a No. 4 Enfield which is not much different. The "No Gunsmithing Required" scope mounts will require you to drill and tap a screw to secure the mount. After the mount was screwed to the bridge it worked fine.

There is one mount that seems to be a real" No Gunsmith Required" scope mount. They are supposed to be coming out with a mount for the No. 1 and Ishapors. Click on the link below and look at CAD Technik.

http://www.303british.com/

Warren

JIMM · 03-26-2002, 09:45 PM

I put a no gunsmithing scope mount on my Ishapor .The only thing I had to do was to remove the rear sight by removing a pin and sweating off the rear sight with a propane torch so I could slide a ring down the barrel to the receiver then reverse the process it seems to work well enough. I think it is an S&k.

Mike southers · 04-16-2002, 02:39 PM

I think Brownells sells one. It requires removing the safety and extractor screws, then uses the knurled knobs on the mount to hold those two and the mount in place.

03-22-2002, 09:57 PM	#1
willys Member Join Date: Mar 2002 Location: TEXAS Posts: 64 Trader Rating: (0)	No.1 MK2 3A I have an Enfield NO.1 MK2 3A. has anyone tried to mount a scope to one of these?

03-24-2002, 03:40 AM	#2
warren47 Registered User Join Date: Mar 2002 Location: Michigan Posts: 8 Trader Rating: (0)	Scope mount I mounted a scope on a No. 4 Enfield which is not much different. The "No Gunsmithing Required" scope mounts will require you to drill and tap a screw to secure the mount. After the mount was screwed to the bridge it worked fine. There is one mount that seems to be a real" No Gunsmith Required" scope mount. They are supposed to be coming out with a mount for the No. 1 and Ishapors. Click on the link below and look at CAD Technik. http://www.303british.com/ Warren

04-16-2002, 02:39 PM	#4
Mike southers Senior Member Join Date: Mar 2002 Location: middle coast Posts: 162 Trader Rating: (0)	Re: scope mount I think Brownells sells one. It requires removing the safety and extractor screws, then uses the knurled knobs on the mount to hold those two and the mount in place.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-26-2002, 09:45 PM	#3
JIMM Member Join Date: Mar 2002 Location: cincinnati ohio Posts: 48 Trader Rating: (0)	I put a no gunsmithing scope mount on my Ishapor .The only thing I had to do was to remove the rear sight by removing a pin and sweating off the rear sight with a propane torch so I could slide a ring down the barrel to the receiver then reverse the process it seems to work well enough. I think it is an S&k.