Reducing Pa-63 trigger pull

Zen900 · 11-16-2006, 11:11 PM

.
I removed 1/4" from the old trigger/hammer spring and achieved a very user friendly trigger. I doubt you could remove more than 1/4" but I recommend removing lengths in 1/8" increments. The trigger pull origonally was around 15lbs now its a fourth of that. You probably don't need a new trigger spring however the recoil spring was useless mush and had to be replaced.

dgray64 · 09-07-2007, 09:47 PM

Try the Wolff Co 11# spring for the recoil and the hammer (2 springs), plus get a new firing pin spring as well and enjoy a NEW GUN!

Dave

11-16-2006, 11:11 PM	#1
Zen900 Senior Member Join Date: Dec 2005 Posts: 673	Reducing Pa-63 trigger pull . I removed 1/4" from the old trigger/hammer spring and achieved a very user friendly trigger. I doubt you could remove more than 1/4" but I recommend removing lengths in 1/8" increments. The trigger pull origonally was around 15lbs now its a fourth of that. You probably don't need a new trigger spring however the recoil spring was useless mush and had to be replaced.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-07-2007, 09:47 PM	#2
dgray64 Senior Member Join Date: Aug 2007 Location: central Texas Posts: 195	Try the Wolff Co 11# spring for the recoil and the hammer (2 springs), plus get a new firing pin spring as well and enjoy a NEW GUN! Dave