Problem with mag & JHP

phxbird · 04-02-2007, 03:12 PM

I picked up some JHP for my p-63. I have two different mag. for it. One has a bluing and the other a grey finish. The blue one would take the Jhp but not liking it and the grey one would jam. I eye balled both fmj & the jhp it looked the same size. Any one run in to something like this. I could get about 3 or 4 bolts in the mag and then tell that there was not spring tension.

Rich

beemerb · 04-12-2007, 10:21 PM

Check your feedramp.Some i have seen have a step in the bottom that hangs HP's up.
Bob

04-02-2007, 03:12 PM	#1
phxbird Registered User Join Date: Mar 2007 Location: PHX AZ Posts: 9	Problem with mag & JHP I picked up some JHP for my p-63. I have two different mag. for it. One has a bluing and the other a grey finish. The blue one would take the Jhp but not liking it and the grey one would jam. I eye balled both fmj & the jhp it looked the same size. Any one run in to something like this. I could get about 3 or 4 bolts in the mag and then tell that there was not spring tension. Rich

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-12-2007, 10:21 PM	#2
beemerb Registered User Join Date: Mar 2007 Location: AZ Posts: 2	Check your feedramp.Some i have seen have a step in the bottom that hangs HP's up. Bob