Welcome to the New GunAndGame.com
Send Feedback - Back to the Old GunAndGame

Go Back   Gun and Game Forums > Firearms > Military Firearms > M1 Garand

Notices

Reply
 
Thread Tools
Old 01-26-2003, 03:20 PM   #1
Member
 
Join Date: Mar 2002
Location: Atlanta
Posts: 58
Repair near a cartouche

Hey stock doc, would you fix this or leave it alone. Looks like a pair of plyres got ahold of it. Thanks.
Attached Images
File Type: jpg jlg sa.jpg (57.1 KB, 95 views)
__________________
JackT
"NUTS!!"
JackT is offline   Reply With Quote
Old 01-26-2003, 05:46 PM   #2
Moderator
 
Stock Doc's Avatar
 
Join Date: Mar 2002
Location: North Middle Ohio I see water
Posts: 838
If it were mine and it was a original I would think hard about it. Otherwise you can clean the area with Acetone then set some water on the Sight knurl marks a few times until it lifts a bit then take 220 sand paper very cautiously and lightly touch area to knock down the knurl marks and 0000 steel wool then oil. If color is to light take a Q-tip and add a touch of Chestnut Ridge stain and oil again. Repeat until happy.
Also if you clean the entire stock for a complete refinish it will lift those marks most probably. Remember you can always refinish but you cant take it back when done. If done properly it will be fine unless you refinish it to a mint smooth finish then it will look out of place. Some scars are a must and should be worn to show some history. Hope this helps. Rick B
__________________
If I cant fix it,, It must REALLY be broken!
Stock Doc is offline   Reply With Quote
Old 01-26-2003, 07:30 PM   #3
Member
 
Join Date: Mar 2002
Location: Atlanta
Posts: 58
It is an original, just got it from the CMP. I'll probably leave it alone. Thankd
__________________
JackT
"NUTS!!"
JackT is offline   Reply With Quote
Reply

Tags
repair, near, cartouche

Thread Tools

Forum Jump


All times are GMT -5. The time now is 04:00 AM.


[Output: 49.03 Kb. compressed to 46.72 Kb. by saving 2.31 Kb. (4.71%)]