04-25-2008, 03:41 PM
| #1 |
| Senior Member Join Date: Mar 2008 Location: Kotzebue, Alaska
Posts: 311
| Carcano tolerances I would like some published data on carcano tolerances. |
|  |
|
04-25-2008, 03:46 PM
| #2 |
| Senior Member  Join Date: Mar 2008 Location: eastman GA
Posts: 1,344
| I dont know if this will help but here it is. Carcano Homepage: Italian Military Rifles and Carbines you might be able to find info in Bolt Action Rifles by Frank De Haas
__________________ Jan. 4, 2007...Gasoline $2.10/gallon HMMM? Jim  |
| |
|
05-08-2008, 06:04 PM
| #3 |
| Senior Member Join Date: Mar 2008 Location: Kotzebue, Alaska
Posts: 311
| sloppy sear I'm looking at this rifle and its bad trigger pull, I dissembled the bolt and trigger assy's and stoned the mateing surfaces of trigger and sear the back of the striker wobbles up & down when the trigger is worked and contemplating how to take up the freeplay. |
|
| |
|
05-14-2008, 01:49 PM
| #4 |
| Senior Member Join Date: Mar 2008 Location: Kotzebue, Alaska
Posts: 311
| Bad wobble from battle trigger to sporter trigger the wobble of the back end the bolt drops as much as 3/32" while pulling the trigger thru both stages, I'm thinking about a method to reduce the excessive free-play of the back end the bolt, mabe fitting some brass shim stock to support the bottom back end the bolt inside the receiver tang epoxying brass shim stock,J-B weld the area up and file to fit, worse case senario is tig welding up the area's that most the freeplay occors and re-heat treating? am right now swapping out parts to see if it would reduce freeplay, The trigger pin/sear side play is not the main problem, its the designed open tolerences allowing for battle field conditions and the wide rangeing bolt drop to sear release. |
|
| |
Linear Mode
