Valkyrie Arms Grease Guns... and freakish conversions thereof

BattleRifleG3 · 03-07-2004, 03:57 PM

Not sure if FAC is selling the Valkyrie version, but Valkyrie does offer a semi-auto grease gun carbine and now so does FAC, for $650 dealer cost.

Well it's more expensive than that Ruger carbine I want, but it is 45 and does take hi-caps. And to give it some of the same strengths, I was thinking of putting it in a one piece stock. Well, here are some freakish conversion concepts.

Anyone have thoughts on the original, the repro, or the freakish conversions?

BattleRifleG3 · 03-07-2004, 04:01 PM

And here you go

Rave · 03-25-2004, 10:09 AM

Mods don't look bad,might clean up the foregrip in pic three.
pic two would be nice with a small fore grip so you could hold without burning hand and still unscrew barrel quickly,might be wood or perforated metal tacked to threaded section,lots of potential there.
I'll bet it is pretty quiet,especially with standard ball.:nod:

03-07-2004, 03:57 PM	#1
BattleRifleG3 Super Moderator Join Date: Mar 2002 Location: Western PA Posts: 11,397 Images: 13	Valkyrie Arms Grease Guns... and freakish conversions thereof Not sure if FAC is selling the Valkyrie version, but Valkyrie does offer a semi-auto grease gun carbine and now so does FAC, for $650 dealer cost. Well it's more expensive than that Ruger carbine I want, but it is 45 and does take hi-caps. And to give it some of the same strengths, I was thinking of putting it in a one piece stock. Well, here are some freakish conversion concepts. Anyone have thoughts on the original, the repro, or the freakish conversions? __________________ Trust is earned, not... GIVEN away. - Worf Last edited by BattleRifleG3; 03-07-2004 at 04:02 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-25-2004, 10:09 AM	#3
Rave Senior Member Join Date: Mar 2002 Location: Tampa Posts: 6,431	Mods don't look bad,might clean up the foregrip in pic three. pic two would be nice with a small fore grip so you could hold without burning hand and still unscrew barrel quickly,might be wood or perforated metal tacked to threaded section,lots of potential there. I'll bet it is pretty quiet,especially with standard ball.:nod: