Recoil Pad and Tool Kit

dispatch55126 · 03-21-2008, 07:12 PM

I was able to completely take down my SKS without any problems the first day I owned it, but for the life of me I cannot figure out how the cleaning kit trap door goes back on. Also, the pad won't fit right now.

Cyrano · 03-21-2008, 08:24 PM

Make sure you have the pad right side up. It's not ambidexterous. You might have to stretch it a little bit to get it to fit correctly.

The cleaning trap door opens inward, and there is only one way it will fit into the pad and do that. Take the pad off the rifle and fiddle with the trap door where you can see what you are doing to determine which side is 'up.' It took me a minute after I stripped mine down to clean all the cosmoline off it, to get the buttpad and trapdoor back on in the correct position.

racdrof · 03-21-2008, 08:32 PM

Yep, have to agree with Cyrano. Looks like it is upside down.

dispatch55126 · 03-21-2008, 09:15 PM

The taper is correct. I'll play with the trap door and see if it helps.

I should have guessed being a Century. I got the pad to fit. I just had to screw the top down first. The trap door on the other hand is too big for the cutout. My guess is the took it from another rifle that has a wider stock.

I should have guessed being a Century. I got the pad to fit. I just had to screw the top down first. The trap door on the other hand is too big for the cutout. My guess is the took it from another rifle that has a wider stock.

03-21-2008, 07:12 PM	#1
dispatch55126 Member Join Date: Mar 2008 Posts: 19	Recoil Pad and Tool Kit I was able to completely take down my SKS without any problems the first day I owned it, but for the life of me I cannot figure out how the cleaning kit trap door goes back on. Also, the pad won't fit right now.

03-21-2008, 09:15 PM	#4
dispatch55126 Member Join Date: Mar 2008 Posts: 19	The taper is correct. I'll play with the trap door and see if it helps. I should have guessed being a Century. I got the pad to fit. I just had to screw the top down first. The trap door on the other hand is too big for the cutout. My guess is the took it from another rifle that has a wider stock. I should have guessed being a Century. I got the pad to fit. I just had to screw the top down first. The trap door on the other hand is too big for the cutout. My guess is the took it from another rifle that has a wider stock. Last edited by dispatch55126; 03-22-2008 at 11:42 AM. Reason: Automerged Doublepost

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-21-2008, 08:24 PM	#2
Cyrano Senior Member Join Date: Oct 2007 Location: New York Posts: 1,603	Make sure you have the pad right side up. It's not ambidexterous. You might have to stretch it a little bit to get it to fit correctly. The cleaning trap door opens inward, and there is only one way it will fit into the pad and do that. Take the pad off the rifle and fiddle with the trap door where you can see what you are doing to determine which side is 'up.' It took me a minute after I stripped mine down to clean all the cosmoline off it, to get the buttpad and trapdoor back on in the correct position.

03-21-2008, 08:32 PM	#3
racdrof Senior Member Join Date: May 2007 Posts: 153	Yep, have to agree with Cyrano. Looks like it is upside down.