close

Privacy guaranteed - Your email is not shared with anyone.

Bolt disasembly????

Discussion in 'The Powder Keg' started by Doglips, Mar 27, 2002.

  1. Doglips

    Doglips G&G Newbie

    Ok Ive pulled trised, pried and and currently warming up the cutting torch....Like the Mosans I am sure that there is something silly and easy that I am flat over looking...
    So, how does one take the bolt of a turkish mauser apart to clean and check the fireing pin, springs ect?
    :p
     
  2. Will

    Will G&G Newbie

    32
    0

  3. Shaun

    Shaun G&G Evangelist

    try this for instructions
     
  4. Doglips

    Doglips G&G Newbie

    Got it cleaned it...and tried it on a empty case..primer only..made a bigger dent...after 10 trys 1 case fired...2nd case would not...Im goint to pick up some newer ammo....and take it to the range...I guess a few problems from a $40 gun and $5 ammo is to be expected.
     
  5. Shaun

    Shaun G&G Evangelist

    Bob I guess you can classify that in the stuff happens category -- glad to hear its working for you
     
  6. JDW

    JDW G&G Newbie

    36
    0
    ammo

    I've been using that cheap bandoleer stuff, never had one yet that didn't go bang!
    Did you check the headspace? Could that be part of the problem?