close

Privacy guaranteed - Your email is not shared with anyone.

Feg r-61

Discussion in 'FEG' started by CenterMass, Oct 12, 2012.

  1. CenterMass

    CenterMass G&G Newbie

    2
    0
    Does anyone know where I can get magazines, and springs to rebuild a magazine for the R61? This was imported by CAI. then rebarreled to 9mm Short aka .380. I inherieted this pistol. The previous owner cut down the magazine spring.
     
  2. Cyrano

    Cyrano Resident Curmudgeon Forum Contributor

    26,532
    12,457
    New York

  3. DFBonnett

    DFBonnett G&G Regular

    62
    1
    Complete mags are rather scarce. I got a couple on Ebay several years ago but haven't seen any since. You could set up searches on Ebay and Gunbroker that will email you if something turns up. Try Wolff Gunsprings - Firearm Springs for Semi-Auto Pistols, Revolvers, Rifles, & Shotguns for springs. You can order mag springs for a PA-63 and cut them down a bit if you can't get 6 into the mag or you can order a general purpose .32/.380 spring and cut it down to fit.
    FWIW
    YMMV