Gun and Game Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
190 Posts
Discussion Starter · #1 ·
i have a nef pardner sb1 11c, its the one with nickle receiver and synthetic stock and forarm. i noticed today all my frame pins are even on both sides except one, the one on top that goes across and hold the fireing pin and ejector button. was sticking out more on one side it is very noticable, can these move? i have been shooting buckshot and slugs in it. can i tap it back in? if so with what? i have went online to look at pictures and some seem like mine while others look all even. do ya'll think the pin moved or just wasn't tapped all the way thru at factory?. thanks
 

·
Registered
Joined
·
644 Posts
Just tap it back even with the frame. If you don't have a brass hammer, just put a penny on it and tap it with a steel hammer. Tap lightly. It won't take much effort.
 

·
Registered
Joined
·
190 Posts
Discussion Starter · #3 ·
i went to my local shop and looked, some are like mine. the one side is even with the hole at the frame, and on the other the pin is past the hole on the frame.
 
1 - 3 of 3 Posts
Top