Gun and Game Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
294 Posts
Discussion Starter · #1 ·
the safety switch on my gun as recently come off and i very difficult to reattach with out taking it all apart. and the only way to reattach it is to take it a part so how is that done and how do u put it back together :feedback:
 

·
Registered
Joined
·
15,235 Posts
Take the barrel off.Pull the pin that holds the trigger mechanism in and remove the trigger mechanism.The shell stops will fall out.With the slide ahead no further disassembly is necessary to get to the safety.To reassemble after working on safety replace and hold shellstops in and insert and pin trigger mechanism. sam.
 

·
Registered
Joined
·
294 Posts
Discussion Starter · #3 ·
thanks and while i was at it i took the bolt and shell arm off and cleaned it, it was full of weed seeds from hunting
 

·
Registered
Joined
·
17,237 Posts
thanks and while i was at it i took the bolt and shell arm off and cleaned it, it was full of weed seeds from hunting
You shouldn't be smokin so much weed while hunting...
LOL...sorry, i couldn't resist...:34:
Take an old sock ( clean of course) and cut an 8 inch section of the top and slide it over the action when walking in brush, keeps out the trash, and you can pull it back on the stock quickly for a shot !
Rich
 
1 - 4 of 4 Posts
Top