Gun and Game Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 · (Edited)
Transformed my son's bedroom to an "army" camo room for him. Got creative on the gun rack for his AK47(SAR-10). Clip has been welded onto 3/4" wide 1/4" thick steel section. Small hole drilled in center of steel and was welded through hole onto clip. Weld ground down smoothly even. Used sheetrock anchors 2 to a clip so should hold up without problems. Whatcha think?
 

Attachments

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top