PA-63 Grips - Special !

Discussion in 'The Powder Keg' started by JPM, Aug 14, 2002.

Thread Status:
Not open for further replies.
  1. JPM

    JPM Guest

    Well I finally got the first couple of PA-63 grip sets made out of some really cool wood called African Blackwood.

    It's dense enough that it sinks in water! It turns black as it ages and is exposured to sunlight (UV). Part 'o the hang up was finding a source of carbide cutting bit's for the machine I use. It seems this wood is really hard on tool steel....

    There are a few folks who had expressed interest in this project on the prior incarnation of this board....I seem to have lost a few email addresses (or they've changed)...If you are one of those folks and haven't received an email from me, would you please get back in contact? Thanks!

  2. olretiredgunney

    olretiredgunney Guest


  3. Chris

    Chris G&G Evangelist Staff Member Forum Contributor

    This seems like a classified ad to me. Right now this has been halted pending outcome of certain events in the near future. If this is problem please contact me.
Thread Status:
Not open for further replies.