close

Privacy guaranteed - Your email is not shared with anyone.

Performance Center v. standard production

Discussion in 'The Powder Keg' started by Cyclops, Aug 10, 2002.

  1. Cyclops

    Cyclops G&G Newbie

    I think I'll be better off w/ a PC gun but, a buddy of mine tells me to get a 6" 686 have a trigger job done to it, have it ported and put some nice grips on & save some $$ because I won't know the difference between the 2.
    What do ya'll think?
     
  2. NRAJOE

    NRAJOE YOU TALKIN' TO ME!? Forum Contributor

    I'd rather get it done my way, if it was good enough for Frank Sinatra, its good enough for me! :D
     

  3. Eric

    Eric G&G Newbie

    673
    0
    USA
    I think your buddy is probably correct with regards to S&W's wheel guns. If you were going with a semi, I think you would be hard pressed to save money and get the same performance.
     
  4. Cyclops

    Cyclops G&G Newbie

    Been throwing it back & forth. Currently I'm on the standard 357 mag side. Less expensive investment, can have the trigger work done & might have $$ left over to buy ammo with.