close

Privacy guaranteed - Your email is not shared with anyone.

Taurus Triggers

Discussion in 'The Powder Keg' started by Cyclops, Aug 9, 2002.

  1. Cyclops

    Cyclops G&G Newbie

    Tried 2 Taurus revolvers a Tracker and one of their snubbies. Both triggers seemed rather gritty...is this typical? Does it just need a good blast of compressed air to smooth out? What's the deal?
     
  2. I have had both good and bad experiences with their trigger pulls. Try them out. You will find a good one.
     

  3. I just got a 445 snubby with a trigger pull nearly as smooth as my 1967 Colt detective special. My Taurus 689 6" bbl is about equally as good.
     
  4. Cyclops

    Cyclops G&G Newbie

    So, I really do have to try before I buy. I'm glad I didn't just order one.
     
  5. NRAJOE

    NRAJOE YOU TALKIN' TO ME!? Forum Contributor

    I think just abuot any revolver could use a trigger job. Factory has got to make those strong pulls...liability issue.
     
  6. Calvin

    Calvin G&G Newbie

    If you want an easier trigger pull, the easiest mod you can do is to replace the hammer spring. Check out www.gunsprings.com.
    I personally haven't had any trouble with any of my Taurus' triggers, but have heard similar stories such as these. Hope it works out for you guys... :)