Gun and Game Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
2,950 Posts
Discussion Starter · #6 ·
I think I am going to go red-dot.
 

·
Banned
Joined
·
3,876 Posts
Ok SKS, your getting pimp smacked :nod: . You know as well as I do that the receiver cover mounts are junk and wont hold zero. Go wit the scout mount and put a red-dot on it.
 

·
Registered
Joined
·
2,950 Posts
Discussion Starter · #10 · (Edited)
I shot one over the weekend on the AK, it was very stable. I was so surprised. It was a good little mount, about 5 times thicker and stronger than the original.

THe scout mounts are 70 bucks for the mount alone.:mad:
 

·
Registered
Joined
·
2,950 Posts
Discussion Starter · #12 · (Edited)
The way I figure I will get that set-up and if it is junk then I will go with the scout mount and transfer the red-dot over to that. Like I said I shot one over the weekend and I was surprised that it not only worked, but worked pretty well and consistantly holding a zero. I hope this reciver cover is the same one I shot earlier.

going to hold off and get a new tat instead
 

·
Registered
Joined
·
166 Posts
i just picked up a receiver replacment mount for my sks and i was surprised the way it was holding its zero. either somebody is improving them or i just got lucky for once.(never happens :) )
 

·
Banned
Joined
·
3,876 Posts
At some point they will have to get them right. To many people have access to the net and will find these problems out, they'll have to fix it.
 
1 - 14 of 14 Posts
Top